DIY Lucite Framed Scarf

0
177

I love the look of high-end lucite framed scarves, but with retail prices starting at several hundred dollars, they're simply not budget friendly. Luckily for your wallet, making your own is easier than you might think, and with a few simple tools and a little time, you can create your own luxe lucite framed scarf to add to your gallery wall, a blank wall or a bland corner. Requiring only $50 (depending on the price of the scarf) and an afternoon of your time, you can make a custom piece of art that will rival those expense retail versions.

Framed lucite scarf

Things You’ll Need

  • Acrylic sheet 24 inches x 24 inches (x2)

  • Tape measure

  • Standoff (x4) (purchased from Amazon)

  • Permanent marker

  • Drill

  • 3/8-inch masonry drill bit (or any bit with a chisel or cutting end)

  • Scrap wood block to drill into

  • Scarf (eBay and Etsy have a wide selection)

Tip

If your acrylic sheet is larger, you can usually have the store cut it to size for you for free (I went to Lowes). Keep in mind that you want a few inches surrounding the scarf, so measure accordingly.

Materials needed

Step 1: Measure Inset for Standoff Placement

Determine desired inset for standoff. Typically, 1 inch from the center of the standoff is a good starting point.

Measure inset.

Step 2: Mark Center of Standoff

With a permanent marker, mark the center. Repeat for all four corners.

Mark center.

Step 3: Drill Hole for Standoff

On the mark created, use the 3/8-inch masonry bit (or the size of your standoff), drill a hole for each standoff on all four corners. A typical bit will catch and potentially break the fragile acrylic. A masonry bit (or anything with a broad, cutting end) will cut through the acrylic.

Tip

If you don't have a masonry bit, a standard bit will work. Drill in reverse instead of forward. As the bit heats up, this will slowly melt the plastic and reduce the risk of breaking the plastic. Try drilling on a scrap piece of plastic to practice first.

Create holes for the standoffs.

Step 4: Remove the Protective Plastic and Place the Scarf

Remove the protective plastic sheeting and remove any dust with a microfiber cloth. If needed, iron the scarf, center and place it between the sheets of acrylic.

Center and place the scarf.

Tip

I recommend performing this step on a clean white surface, as this will make it easier to see any dust.

Step 5: Apply the Standoffs

Unscrew the standoff, place it through the hole and screw back together. Repeat on all four corners.

Attach the standoff.

Step 6: Hang on Wall

Measure and mark the placement for nails.

Measure the center of stand off from edge of frame.

Hang over a dresser, nightstand, or table and style with your favorite accessories.

Framed lucite scarf Framed lucite scarf

LEAVE A REPLY

Please enter your comment!
Please enter your name here